Indonesia - Japan

• About The Mechanism
• Joint Committee
  • JC Members
  • JC Decision
• Rules and Guidelines
• Third Party Entity
• Methodologies
  • Proposed methodologies
  • Approved methodologies
  • Methodologies under put on hold
• Project Cycle Search
  • Project Cycle Search
  • Request for registration
  • Registered project
  • Issuance of credits
  • Request for post-registration changes
• Contact us
• Link

Methodology : ID_AM025 Ver1.0

Methodology No.	ID_AM025
Proposed Methodology No.	ID_PM035
Sectoral scope	3. Energy demand
Title	Installation of all-electric injection molding machine with power regeneration
Summaries	GHG emission reduction measures : Installation of all-electric injection molding machine with a function of power regeneration leads to reducing electricity consumption by the oil pumps which are used for reference injection molding machine (hydraulic injection molding machine), and consequently GHG emissions. Calculation of reference emissions : Reference emissions are calculated with the electricity consumption of all-electric injection molding machine, reduction ratio of electricity consumption and CO2 emission factor for consumed electricity. Calculation of project emissions : Project emissions are calculated with the electricity consumption of all-electric injection molding machine and CO2 emission factor for consumed electricity. Monitoring parameters : Electricity consumption of the project injection molding machine.
Version Number	Ver1.0
Status	Valid
Methodology Proponent	Tokyo Century Corporation
Approved Methodology	JCM_ID_AM025_ver01.0.pdf JCM_ID_AM025_ver01.0.docx JCM_ID_AM025_ver01.0.xlsx
Proposed Methodology	JCM_ID_PM035_PM.pdf JCM_ID_PM035_PMS.xlsx JCM_ID_PM035_ADD1.pdf
Public comments	03 Sep 20   -  17 Sep 20
Date of approval	23 Dec 20